AnalogicTech’s New Lighting Management Unit Accelerates Smart Phone Design
Advanced Analogic Technologies Inc. (AnalogicTech™) announced the AAT2862, a new lighting management unit (LMU) that drives up to eight LEDs and integrates four low-dropout (LDOs) linear regulators.
Optimized for single-cell Lithium-ion/polymer powered systems, the AAT2862’s unique capabilities are well suited for I²C-based high performance smart phones and other mobile devices that require the integration of two camera modules. The new LMU also adds an automatic fade-in/fade-out backlight control that simplifies design and reduces processor overhead.
"Given the complexity and diversity of feature sets found in today’s cell phone product lines, designers can gain tremendous advantage in terms of design time and cost by using the same power management solution in multiple products," said Phil Dewsbury, Product Line Director for AnalogicTech. "By delivering industry-standard I²C programmability across nine different LED combinations and I²C control across 16 different voltage settings for each LDO, the AAT2862 provides the level of versatility designers require to build complex products in short design cycles."
Operating from a 2.7 to 5.5V input voltage, the AAT2862 drives up to eight backlight LEDs at up to 30mA each. To ensure constant current over the entire battery range, the LEDs are driven from a tri-mode charge pump which automatically switches between 1x, 1.5x and 2x modes to maximize operating efficiency. The charge pump’s high 1 MHz operating frequency permits the use of small 1µF ceramic capacitors.
The eight LED outputs are programmable from 500µA up to 30mA. Two LED outputs can be programmed up to 60mA each. Current can be set to any of 32 separate levels via an industry-standard I²C interface. To ensure uniform display brightness, current matching is better than 3%. To balance power dissipation, high current matching exceeds 5%.
The new LMU also features three programmable automatic fade-in/fade-out times for backlight control. By implementing this function in hardware instead of software, processor overhead is reduced.
The AAT2862 also features four high performance low noise LDOs. The output of each LDO is programmable via the I²C serial interface to any of 16 voltages between 1.2 and 3.3V. Each regulator can supply up to 200mA load current. To support battery-operated applications, ground-pin current is limited to 80µA. To ensure device integrity, the AAT2862 also features automatic soft start and built-in thermal protection.
The AAT2862 is qualified across the -40 to +85°C temperature range. It is available in a PB-free, 24-pin TQFN34 package. It sells for $1.81 in 1K quantities.
